Dear all,
I built a POP PK model, after I finished Predicitive check, I found the output picture was a little strange, the name of Y-axis was "DV0" instead of "DV". Does anyone know why there was a "0" behind the "DV"?
Thanks a lot.
Posted 24 October 2022 - 02:10 AM
Dear all,
I built a POP PK model, after I finished Predicitive check, I found the output picture was a little strange, the name of Y-axis was "DV0" instead of "DV". Does anyone know why there was a "0" behind the "DV"?
Thanks a lot.
Posted 24 October 2022 - 05:56 AM
Crystal, can you post your project, or at least your model code please? Simon
Sure, here is the model code:
Edited by Crystal, 24 October 2022 - 07:01 AM.
Posted 24 October 2022 - 06:35 AM
DV0 is just DV observed i.e your original data the blue points are those original data (pred corrected if you used this option)
so nothing special here
you might want to add the CI in your vpc plot you also might want to look at it versus TAD . pred corrected split by study / study phases
Posted 24 October 2022 - 06:57 AM
thank you very much for your reply~~
DV0 is just DV observed i.e your original data the blue points are those original data (pred corrected if you used this option)
so nothing special here
you might want to add the CI in your vpc plot you also might want to look at it versus TAD . pred corrected split by study / study phases
Certara Forums →
Modelling and Simulation →
Select residual error model and VPC plot with negative valueStarted by joybaker , 19 Nov 2022 VPC, error model |
|
|
||
Certara Forums →
Modelling and Simulation →
PopPK VPC not including all observed data pointsStarted by cardtrick12 , 20 Apr 2022 vpc, poppk |
|
|
||
Certara Forums →
PML School →
Materials from mixed absorption and model validation with VPCStarted by bwendt@certara.com , 24 May 2018 mixed absorption, VPC |
|
|
0 members, 0 guests, 0 anonymous users