5 replies to this topic

[littlepetinga]

Dear All!

 

I kindly ask if it is possible to calculate an additional NCA parameter, for which calculation involves a partial area. If possible, how can I attain so?

 

Thank you very much in advance!

 

Best regards

SCH

[Simon Davis]

Hi Sara,

   Yes this is possible, which version of Phoenix are you using.

For 8.x  this is possible within NCA object itself 

and in earlier versions you can use a data wizard > custom transformation.

 

see screen shot of a dose normalised partial area 0_12h

 

  Simon.

PS if you are planning an upgrade there will be an 8.3 release this summer.

Edited by Simon Davis, 22 May 2020 - 05:32 PM.

[littlepetinga]

Hi Simon

 

Thank you for your answer.

 

I am using Phoenix 8.2. 

 

I have tried to define within the NCA, as you suggested. Although, Phoenix gives an error, that the variable (partial area) is not valid.

 

Can it be due to partial areas being defined in an external worksheet?

 

Once again thank you for your help!

 

Rgds

Sara

 

 

Hi Sara,

   Yes this is possible, which version of Phoenix are you using.

For 8.x  this is possible within NCA object itself 

and in earlier versions you can use a data wizard > custom transformation.

 

see screen shot of a dose normalised partial area 0_12h

 

  Simon.

PS if you are planning an upgrade there will be an 8.3 release this summer.

[Simon Davis]

Sara, I think I would need to look at the project to see what you have done. if you aren't happy to share an example on this forum then I suggest you email support.

 

 Simon.

Edited by Simon Davis, 28 May 2020 - 08:25 AM.

[littlepetinga]

Hi Simon,

 

It's a pleasure to share the project with you. How would you advise-me to send it to you.

 

Thank you very much for your help!

 

Sara

[Simon Davis]

As a Support case please. email TO support@certara.com and a case number will be assigned to you.